HDPE double wall corrugated pipe maintenance method?



Number of views:

With the rapid development of urban planning and construction, now we have all seen the fact thatHDPE double-wall corrugated pipeIt has been widely used in various construction projects as early as possible, and its advantages have been recognized by everyone. In order to make better use, let's learn about the correct maintenance methods of HDPE double-wall corrugated pipe.

HDPE double-wall corrugated pipe in the use of the process without the corresponding maintenance of the pipeline, will greatly reduce the service life of the water pipe. Therefore, in order to extend the service life of the water pipe, we need to pay attention to the long-term exposure of the HDPE double-wall corrugated pipe. In this case, in fact, this product will not only lead to the aging of the pipeline, performance degradation, but also due to the sunlight through the pipe wall and lead to a large number of microorganisms on the pipe wall, resulting in the water supply pipe is covered with a lot of moss, affecting the use. When the weather is cold, the plastic pipe will become brittle, and once the water in the pipe freezes, the pipe will burst. Avoid prolonged exposure to the sun or too cold water supply pipes, try not to use exposed water pipes, or add insulation materials to exposed places, and drain the water in the water pipes on cold winter nights. If the HDPE double-wall corrugated pipe is damaged or the damaged area is too large to be repaired, the damaged part can be removed, and the HDPE double-wall corrugated pipe detection connection can be installed to save the material cost. This is a disguised repair. If this HDPE double-wall corrugated pipe is seriously damaged and cannot be repaired, it needs to be replaced and is prohibited from use.

If HDPE double-wall corrugated pipe needs to be drained from the corrugated pipe after the construction is completed, it is recommended that you can also use a carving knife to repair the damaged part, remove the dirt and a rag, or use a file to polish the surface of the emery cloth, and then only use the maintenance paste. Double-wall corrugated pipe in the transport or use of local damage, can be pasted repair, and does not exceed the requirements. If its damaged area is larger, of course, can use heat shrinkable sleeve repair. It should be pointed out that the damaged area needs to be placed on the top of the bellows to avoid damage to the leakage area. When conditions permit, the adhesive used to fix the damaged part of the bandage can be used to ensure the quality of the repaired double-wall bellows when repairing the damaged part. Of course, the blockage of this product is common. One of the reasons for the blockage is that there is a foreign body stuck in a certain part of the water pipe. The blockage of water pipes not only brings trouble to people's lives, but also causes excessive pressure on the local water pipes and affects the service life of the water pipes. Of course, in order to avoid clogging, a floor drain can be installed at the drain pipe to prevent excessive foreign matter from entering the water pipe. Although the hardness of HDPE double-wall corrugated pipe is constantly improving, it will also cause pipe explosion and water leakage due to excessive external pressure. Therefore, when installing, it is recommended that everyone try to install the water pipe on the top of the room, not only to avoid bursting and water leakage caused by excessive pressure, but also to avoid hitting the ground to repair the water pipe when it leaks.

After the introduction of the above content, we also have a further understanding of the maintenance method of HDPE double wall corrugated pipe. When I see him again in the future, I will not feel strange, and there will be no frequent problems in the process of using it. Well, that's all for today.